![]() Mounting screws are located inside the battery compartment. Mounting InstructionsThe keypad must be mounted in sight of the door(s), at least 5 feet above the ground and clear of any moving door parts. After a few seconds the LED will turn off. Rapid blinking of the red LED indicates an error. Any keypad button will control the door for 30 seconds after the door starts moving. After the LED stops blinking, re-enter your PIN ad try again. If the LED is blinking rapidly, the PIN was entered incorrectly. NOTE: If the door does not move, check the LED on the keypad. Select first opener and press and hold the PROGRAM/SET button until both LED lights turn BLUE.Press the number of doors you wish to control (2 or 3).Enter your PIN and press the PROGRAM button.Program the keypad for multiple doorsAll garage door openers will use the same PIN. Program Keypad for Multiple Garage Door (CodeDodger 2) Create Your Wireless Keypad PIN (Personal Identification Number) The keypad backlight will turn off in approximately 30 seconds.(It will automatically stop at the fully open or fully closed position.) Enter your PIN number using the keys on the keypad.Press and hold the PROGRAM button again then release.Press and hold the PROGRAM button until both LED lights turn BLUE.Program the keypad for a single doorOn the power head: Wireless Keypad ( Model OKP-BX) with CodeDodger ® Program Keypad for One Garage Door (CodeDodger 2) Create Your Wireless Keypad PIN (Personal Identification Number) On your wireless keypad: Mark the bottom hole, then screw in the bottom screw.Īdditional AssistanceShould you need additional information about installing or programming your garage door opener or remote, please call customer service at 1-80, or use our distributor locator to find a Red Ribbon Distributor near you.Install a screw into the top drilled hole, leaving a 1/8" gap between the screw head and the wall.Drill a 1/16" hole for the top mounting screw.If the red LED does not blink during use, the battery needs to be changed.After a few seconds, the LED will turn off, and you can retry. Rapid blinking of the LED indicates an error.Any keypad button will control the door for 30 seconds after the door starts moving. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |